Linux command
ip-netconf 命令
网络
Copy it and replace filenames, paths, or keywords as needed.
命令示例
Example
ip netconf
Example
ip netconf show dev eth0
Example
ip -4 netconf
Example
ip -6 netconf
说明
ip netconf monitors and displays IPv4 and IPv6 network configuration parameters from /proc/sys/net/ipv4|6/conf/. It shows settings like forwarding status, RPF (Reverse Path Filtering) mode, MC forwarding, and proxy ARP/NDP status. If no interface is specified, the all entry is displayed.
参数
- show
- Show network configuration (default if omitted)
- dev NAME
- Show configuration for specific interface
- help
- Display help information
FAQ
What is the ip-netconf command used for?
ip netconf monitors and displays IPv4 and IPv6 network configuration parameters from /proc/sys/net/ipv4|6/conf/. It shows settings like forwarding status, RPF (Reverse Path Filtering) mode, MC forwarding, and proxy ARP/NDP status. If no interface is specified, the all entry is displayed.
How do I run a basic ip-netconf example?
Run `ip netconf` in a terminal, then adjust file names, paths, flags, or remote targets for your system.
What does show do in ip-netconf?
Show network configuration (default if omitted)